Spring loaded sensor bracket with bellow suction cup, for utmost sensor contact on inclined or ondulated sheet stacks.

Application Characteristics

For vertical destacker:+
For robot loader and high speed linear destackers:
For inclined sheet stacks:+
For Tailor Welded Blanks + TWB+
(Legend: "- -" = absolutely not suited / "-" = not suited / "o" = applicable / "+" = well suited / "++" = best suited)

Technical Data

Suitable sensors:P42GS, P42AGS, PW42GS, PW42AGS
Diameter of suction cup:105mm
Spring travel:approx. 34mm, plus approx. 20mm compression travel
Total height (unloaded):approx. 128mm
Weight:approx. 1.2kg (2.64lbs) /
approx. 0.75kg (1.87lbs) (SHS42G-FB80)
Mounting:Hole 20.5mm for SHK clamping device
Pressure force at 1/2 spring travel:approx. 60N
Sensor mounting:Thread M42 x 1.5
Vacuum feed:Hose 8mm OD
Suction delay time:*approx. 0.5s
* is heavily dependent on vacuum strength, piping resistance, contact angle and contact pressure to the sheet. Sensor brackets are not suited for lifting. (except sheet is smaller than area of 3 suction cups)


  • SHS42G-FB_GE (yellow)
    Bellow suction cup, hardness 55 shore


Powered by